Hi gang,
I mentioned this the other day in another post, but want to pull the string on this and see if it's just me or a widespread problem with Hollister Lock N Roll closure bags. Check out the pics below to see what I'm talking about. I've seen both sides leak in the same location relative to the seal. I think what's happening is when you roll up the closure... any air or output gets rolled up to this point under the closure and then when you squeeze the closure shut on each end to seal it any trapped air or output has nowhere to go... and overpressurizes the plastic... and it blows out.
I've looked at a number of bags under magnification and they all fail the same way at the same locations. I've stopped it by thoroughly drying the bag in that location and putting a piece of Scotch Tape over the rip. But I shouldn't have to. I'm going to contact Hollister, but wanted to know if anyone else is having the same issue.
Seems I can only upload one pic per post, so I'll put the blowup of the area leaking in the next post.
Thanks,
Bob